More Skirt Panels

Spent the evening cutting out the rest of the skirt panels and then trimming the edges and sanding them to fit. It looks like they'll line up right once they're nailed and glued into place. They're just sort of leaning in place in these photos.

I still have to cut out the holes in each panel for the hemispheres first though. I'm also trying to decide if I should paint the panels before or after attaching them.

Dalek Bumps!

"They're etheric beam locators."

The hemispheres I'm going to use for the skirt arrived today! I don't really have the time or space (or patience) to make them myself with a mold so I got these from Barnard Ltd.

They should push through the holes I'm going drill in the skirt panels nicely.

Skirt Panels

Started cutting out the skirt panels today.

I'm using 1/8" MDF for these to keep the weight down a little bit. It's also much easier to cut.

Going to get them all cut out and make sure they fit properly and then cut the holes for the hemispheres. Planning on putting the hemispheres in before permanently attaching the panels to the skirt because the struts will be in the way if I try to do it later.

More Wheels

I decided to add two more wheels to the bottom after a brief "test drive" of the skirt section. I tried to place the wheels wherever there was more weight on the bottom, like under the vertical supports (which also have the seat attached.) It ended up being a bit wobbly at the back and moving in reverse felt a little tough. It's a lot smoother now.

Also painted the bumper. It's a little thinner than it should be I think, but I'm going to look for some sort of rubber maybe to put around it anyway.



Dalek Skirt, part 5

Wheels...

...and the mostly complete skirt frame (still need to put the seat panel in. and some sort of latch to keep the parts together)



Dalek Skirt, part 4

I got quite a bit done today!

Here's the lower layer of the base with the trim attached with nails and wood glue (and lots of spackle to fill in cracks and gaps and make things look smoother.

Got some work done on the upper part of the skirt as well.

Just wanted to make sure the supports for the seat were sturdy...

and here it is with the front half.

Still need to cut the front strut and stick it in there. Also need to put a sheet of plywood in for the seat.

I think this might actually work out!









Brendan vs. The Feet-hole

Finally finished cutting out the hole in the lower part of the base. It was extra tricky because there's no easy way in with a hand saw. So I drilled holes around the edges and then hacked away at the smaller bits that were left until i could basically punch out the middle (and then sanded the edges).

Did I mention I'm making the bottom part of the base in 2 parts? I need the base to split for transportation reasons (and I suspect this will make it easier to get in and out of). But rather than use one REALLY thick piece of plywood or MDF for the bottom, I'm using 2 pieces  of 1/2" (well, a little over 1/2" - it's in millimeters, but i forget how many exactly... anyway) to make the bottom about 1" thick with the wheels and trim attached to the bottom layer, and the top layer split for attaching the rest of the skirt.

My big reasons for this:

 1. thinner pieces of wood to cut - remember, no power saw (I really should have just saved up for one of those)

 2. just seems like it would be more stable with the split

 3. if at some point I want to make the bigger MK2 base with larger wheels for outdoor use/invasion, I can just make that separately and pop the existing skirt on it.